/******************************************************************************
*
* Copyright (C) 1999-2012 Broadcom Corporation
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at:
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*
******************************************************************************/
#ifndef __CONFIG_H
#define __CONFIG_H
#ifdef __cplusplus
extern "C"
{
#endif
int GetStrValue(const char* name, char* p_value, unsigned long len);
int GetNumValue(const char* name, void* p_value, unsigned long len);
#ifdef __cplusplus
};
#endif
#define NAME_POLLING_TECH_MASK "POLLING_TECH_MASK"
#define NAME_REGISTER_VIRTUAL_SE "REGISTER_VIRTUAL_SE"
#define NAME_APPL_TRACE_LEVEL "APPL_TRACE_LEVEL"
#define NAME_USE_RAW_NCI_TRACE "USE_RAW_NCI_TRACE"
#define NAME_LOGCAT_FILTER "LOGCAT_FILTER"
#define NAME_LPTD_CFG "LPTD_CFG"
#define NAME_SCREEN_OFF_POWER_STATE "SCREEN_OFF_POWER_STATE"
#define NAME_PREINIT_DSP_CFG "PREINIT_DSP_CFG"
#define NAME_DTA_START_CFG "DTA_START_CFG"
#define NAME_TRANSPORT_DRIVER "TRANSPORT_DRIVER"
#define NAME_POWER_CONTROL_DRIVER "POWER_CONTROL_DRIVER"
#define NAME_PROTOCOL_TRACE_LEVEL "PROTOCOL_TRACE_LEVEL"
#define NAME_UART_PORT "UART_PORT"
#define NAME_UART_BAUD "UART_BAUD"
#define NAME_UART_PARITY "UART_PARITY"
#define NAME_UART_STOPBITS "UART_STOPBITS"
#define NAME_UART_DATABITS "UART_DATABITS"
#define NAME_CLIENT_ADDRESS "BCMI2CNFC_ADDRESS"
#define NAME_NFA_DM_START_UP_CFG "NFA_DM_START_UP_CFG"
#define NAME_NFA_DM_CFG "NFA_DM_CFG"
#define NAME_NFA_DM_LP_CFG "NFA_DM_LP_CFG"
#define NAME_LOW_SPEED_TRANSPORT "LOW_SPEED_TRANSPORT"
#define NAME_NFC_WAKE_DELAY "NFC_WAKE_DELAY"
#define NAME_NFC_WRITE_DELAY "NFC_WRITE_DELAY"
#define NAME_PERF_MEASURE_FREQ "REPORT_PERFORMANCE_MEASURE"
#define NAME_READ_MULTI_PACKETS "READ_MULTIPLE_PACKETS"
#define NAME_POWER_ON_DELAY "POWER_ON_DELAY"
#define NAME_PRE_POWER_OFF_DELAY "PRE_POWER_OFF_DELAY"
#define NAME_POST_POWER_OFF_DELAY "POST_POWER_OFF_DELAY"
#define NAME_CE3_PRE_POWER_OFF_DELAY "CE3_PRE_POWER_OFF_DELAY"
#define NAME_NFA_STORAGE "NFA_STORAGE"
#define NAME_NFA_DM_START_UP_VSC_CFG "NFA_DM_START_UP_VSC_CFG"
#define NAME_NFA_DTA_START_UP_VSC_CFG "NFA_DTA_START_UP_VSC_CFG"
#define NAME_UICC_LISTEN_TECH_MASK "UICC_LISTEN_TECH_MASK"
#define NAME_UICC_LISTEN_TECH_EX_MASK "UICC_LISTEN_TECH_EXCLUDE_MASK"
#define NAME_SNOOZE_MODE_CFG "SNOOZE_MODE_CFG"
#define NAME_NFA_DM_DISC_DURATION_POLL "NFA_DM_DISC_DURATION_POLL"
#define NAME_SPD_DEBUG "SPD_DEBUG"
#define NAME_SPD_MAXRETRYCOUNT "SPD_MAX_RETRY_COUNT"
#define NAME_SPI_NEGOTIATION "SPI_NEGOTIATION"
#define NAME_AID_FOR_EMPTY_SELECT "AID_FOR_EMPTY_SELECT"
#define NAME_PRESERVE_STORAGE "PRESERVE_STORAGE"
#define NAME_NFA_MAX_EE_SUPPORTED "NFA_MAX_EE_SUPPORTED"
#define NAME_NFCC_ENABLE_TIMEOUT "NFCC_ENABLE_TIMEOUT"
#define NAME_NFA_DM_PRE_DISCOVERY_CFG "NFA_DM_PRE_DISCOVERY_CFG"
#define NAME_POLL_FREQUENCY "POLL_FREQUENCY"
#define NAME_XTAL_HARDWARE_ID "XTAL_HARDWARE_ID"
#define NAME_XTAL_FREQUENCY "XTAL_FREQUENCY"
#define NAME_XTAL_FREQ_INDEX "XTAL_FREQ_INDEX"
#define NAME_XTAL_PARAMS_CFG "XTAL_PARAMS_CFG"
#define NAME_EXCLUSIVE_SE_ACCESS "EXCLUSIVE_SE_ACCESS"
#define NAME_DBG_NO_UICC_IDLE_TIMEOUT_TOGGLING "DBG_NO_UICC_IDLE_TIMEOUT_TOGGLING"
#define NAME_PRESENCE_CHECK_ALGORITHM "PRESENCE_CHECK_ALGORITHM"
#define NAME_ALLOW_NO_NVM "ALLOW_NO_NVM"
#define NAME_DEVICE_HOST_WHITE_LIST "DEVICE_HOST_WHITE_LIST"
#define NAME_POWER_OFF_MODE "POWER_OFF_MODE"
#define NAME_GLOBAL_RESET "DO_GLOBAL_RESET"
#define NAME_NCI_HAL_MODULE "NCI_HAL_MODULE"
#define NAME_NFA_POLL_BAIL_OUT_MODE "NFA_POLL_BAIL_OUT_MODE"
#define NAME_NFA_PROPRIETARY_CFG "NFA_PROPRIETARY_CFG"
#define LPTD_PARAM_LEN (40)
// default configuration
#define default_transport "/dev/bcm2079x"
#define default_storage_location "/data/nfc"
struct tUART_CONFIG {
int m_iBaudrate; // 115200
int m_iDatabits; // 8
int m_iParity; // 0 - none, 1 = odd, 2 = even
int m_iStopbits;
};
extern struct tUART_CONFIG uartConfig;
#define MAX_CHIPID_LEN (16)
void readOptionalConfig(const char* option);
/* Snooze mode configuration structure */
typedef struct
{
unsigned char snooze_mode; /* Snooze Mode */
unsigned char idle_threshold_dh; /* Idle Threshold Host */
unsigned char idle_threshold_nfcc; /* Idle Threshold NFCC */
unsigned char nfc_wake_active_mode; /* NFC_LP_ACTIVE_LOW or NFC_LP_ACTIVE_HIGH */
unsigned char dh_wake_active_mode; /* NFC_LP_ACTIVE_LOW or NFC_LP_ACTIVE_HIGH */
} tSNOOZE_MODE_CONFIG;
#endif