filter.txt: Linux Socket Filtering
Written by: Jay Schulist <jschlst@samba.org>

Introduction
============

	Linux Socket Filtering is derived from the Berkeley
Packet Filter. There are some distinct differences between
the BSD and Linux Kernel Filtering.

Linux Socket Filtering (LSF) allows a user-space program to
attach a filter onto any socket and allow or disallow certain
types of data to come through the socket. LSF follows exactly
the same filter code structure as the BSD Berkeley Packet Filter
(BPF), so referring to the BSD bpf.4 manpage is very helpful in
creating filters.

LSF is much simpler than BPF. One does not have to worry about
devices or anything like that. You simply create your filter
code, send it to the kernel via the SO_ATTACH_FILTER ioctl and
if your filter code passes the kernel check on it, you then
immediately begin filtering data on that socket.

You can also detach filters from your socket via the
SO_DETACH_FILTER ioctl. This will probably not be used much
since when you close a socket that has a filter on it the
filter is automagically removed. The other less common case
may be adding a different filter on the same socket where you had another
filter that is still running: the kernel takes care of removing
the old one and placing your new one in its place, assuming your
filter has passed the checks, otherwise if it fails the old filter
will remain on that socket.

Examples
========

Ioctls-
setsockopt(sockfd, SOL_SOCKET, SO_ATTACH_FILTER, &Filter, sizeof(Filter));
setsockopt(sockfd, SOL_SOCKET, SO_DETACH_FILTER, &value, sizeof(value));

See the BSD bpf.4 manpage and the BSD Packet Filter paper written by
Steven McCanne and Van Jacobson of Lawrence Berkeley Laboratory.