/*
* arch/arm/mach-orion5x/db88f5281-setup.c
*
* Marvell Orion-2 Development Board Setup
*
* Maintainer: Tzachi Perelstein <tzachi@marvell.com>
*
* This file is licensed under the terms of the GNU General Public
* License version 2. This program is licensed "as is" without any
* warranty of any kind, whether express or implied.
*/
#include <linux/gpio.h>
#include <linux/kernel.h>
#include <linux/init.h>
#include <linux/platform_device.h>
#include <linux/pci.h>
#include <linux/irq.h>
#include <linux/mtd/physmap.h>
#include <linux/mtd/nand.h>
#include <linux/timer.h>
#include <linux/mv643xx_eth.h>
#include <linux/i2c.h>
#include <asm/mach-types.h>
#include <asm/mach/arch.h>
#include <asm/mach/pci.h>
#include <mach/orion5x.h>
#include <linux/platform_data/mtd-orion_nand.h>
#include "common.h"
#include "mpp.h"
/*****************************************************************************
* DB-88F5281 on board devices
****************************************************************************/
/*
* 512K NOR flash Device bus boot chip select
*/
#define DB88F5281_NOR_BOOT_BASE 0xf4000000
#define DB88F5281_NOR_BOOT_SIZE SZ_512K
/*
* 7-Segment on Device bus chip select 0
*/
#define DB88F5281_7SEG_BASE 0xfa000000
#define DB88F5281_7SEG_SIZE SZ_1K
/*
* 32M NOR flash on Device bus chip select 1
*/
#define DB88F5281_NOR_BASE 0xfc000000
#define DB88F5281_NOR_SIZE SZ_32M
/*
* 32M NAND flash on Device bus chip select 2
*/
#define DB88F5281_NAND_BASE 0xfa800000
#define DB88F5281_NAND_SIZE SZ_1K
/*
* PCI
*/
#define DB88F5281_PCI_SLOT0_OFFS 7
#define DB88F5281_PCI_SLOT0_IRQ_PIN 12
#define DB88F5281_PCI_SLOT1_SLOT2_IRQ_PIN 13
/*****************************************************************************
* 512M NOR Flash on Device bus Boot CS
****************************************************************************/
static struct physmap_flash_data db88f5281_boot_flash_data = {
.width = 1, /* 8 bit bus width */
};
static struct resource db88f5281_boot_flash_resource = {
.flags = IORESOURCE_MEM,
.start = DB88F5281_NOR_BOOT_BASE,
.end = DB88F5281_NOR_BOOT_BASE + DB88F5281_NOR_BOOT_SIZE - 1,
};
static struct platform_device db88f5281_boot_flash = {
.name = "physmap-flash",
.id = 0,
.dev = {
.platform_data = &db88f5281_boot_flash_data,
},
.num_resources = 1,
.resource = &db88f5281_boot_flash_resource,
};
/*****************************************************************************
* 32M NOR Flash on Device bus CS1
****************************************************************************/
static struct physmap_flash_data db88f5281_nor_flash_data = {
.width = 4, /* 32 bit bus width */
};
static struct resource db88f5281_nor_flash_resource = {
.flags = IORESOURCE_MEM,
.start = DB88F5281_NOR_BASE,
.end = DB88F5281_NOR_BASE + DB88F5281_NOR_SIZE - 1,
};
static struct platform_device db88f5281_nor_flash = {
.name = "physmap-flash",
.id = 1,
.dev = {
.platform_data = &db88f5281_nor_flash_data,
},
.num_resources = 1,
.resource = &db88f5281_nor_flash_resource,
};
/*****************************************************************************
* 32M NAND Flash on Device bus CS2
****************************************************************************/
static struct mtd_partition db88f5281_nand_parts[] = {
{
.name = "kernel",
.offset = 0,
.size = SZ_2M,
}, {
.name = "root",
.offset = SZ_2M,
.size = (SZ_16M - SZ_2M),
}, {
.name = "user",
.offset = SZ_16M,
.size = SZ_8M,
}, {
.name = "recovery",
.offset = (SZ_16M + SZ_8M),
.size = SZ_8M,
},
};
static struct resource db88f5281_nand_resource = {
.flags = IORESOURCE_MEM,
.start = DB88F5281_NAND_BASE,
.end = DB88F5281_NAND_BASE + DB88F5281_NAND_SIZE - 1,
};
static struct orion_nand_data db88f5281_nand_data = {
.parts = db88f5281_nand_parts,
.nr_parts = ARRAY_SIZE(db88f5281_nand_parts),
.cle = 0,
.ale = 1,
.width = 8,
};
static struct platform_device db88f5281_nand_flash = {
.name = "orion_nand",
.id = -1,
.dev = {
.platform_data = &db88f5281_nand_data,
},
.resource = &db88f5281_nand_resource,
.num_resources = 1,
};
/*****************************************************************************
* 7-Segment on Device bus CS0
* Dummy counter every 2 sec
****************************************************************************/
static void __iomem *db88f5281_7seg;
static struct timer_list db88f5281_timer;
static void db88f5281_7seg_event(unsigned long data)
{
static int count = 0;
writel(0, db88f5281_7seg + (count << 4));
count = (count + 1) & 7;
mod_timer(&db88f5281_timer, jiffies + 2 * HZ);
}
static int __init db88f5281_7seg_init(void)
{
if (machine_is_db88f5281()) {
db88f5281_7seg = ioremap(DB88F5281_7SEG_BASE,
DB88F5281_7SEG_SIZE);
if (!db88f5281_7seg) {
printk(KERN_ERR "Failed to ioremap db88f5281_7seg\n");
return -EIO;
}
setup_timer(&db88f5281_timer, db88f5281_7seg_event, 0);
mod_timer(&db88f5281_timer, jiffies + 2 * HZ);
}
return 0;
}
__initcall(db88f5281_7seg_init);
/*****************************************************************************
* PCI
****************************************************************************/
static void __init db88f5281_pci_preinit(void)
{
int pin;
/*
* Configure PCI GPIO IRQ pins
*/
pin = DB88F5281_PCI_SLOT0_IRQ_PIN;
if (gpio_request(pin, "PCI Int1") == 0) {
if (gpio_direction_input(pin) == 0) {
irq_set_irq_type(gpio_to_irq(pin), IRQ_TYPE_LEVEL_LOW);
} else {
printk(KERN_ERR "db88f5281_pci_preinit failed to "
"set_irq_type pin %d\n", pin);
gpio_free(pin);
}
} else {
printk(KERN_ERR "db88f5281_pci_preinit failed to gpio_request %d\n", pin);
}
pin = DB88F5281_PCI_SLOT1_SLOT2_IRQ_PIN;
if (gpio_request(pin, "PCI Int2") == 0) {
if (gpio_direction_input(pin) == 0) {
irq_set_irq_type(gpio_to_irq(pin), IRQ_TYPE_LEVEL_LOW);
} else {
printk(KERN_ERR "db88f5281_pci_preinit failed "
"to set_irq_type pin %d\n", pin);
gpio_free(pin);
}
} else {
printk(KERN_ERR "db88f5281_pci_preinit failed to gpio_request %d\n", pin);
}
}
static int __init db88f5281_pci_map_irq(const struct pci_dev *dev, u8 slot,
u8 pin)
{
int irq;
/*
* Check for devices with hard-wired IRQs.
*/
irq = orion5x_pci_map_irq(dev, slot, pin);
if (irq != -1)
return irq;
/*
* PCI IRQs are connected via GPIOs.
*/
switch (slot - DB88F5281_PCI_SLOT0_OFFS) {
case 0:
return gpio_to_irq(DB88F5281_PCI_SLOT0_IRQ_PIN);
case 1:
case 2:
return gpio_to_irq(DB88F5281_PCI_SLOT1_SLOT2_IRQ_PIN);
default:
return -1;
}
}
static struct hw_pci db88f5281_pci __initdata = {
.nr_controllers = 2,
.preinit = db88f5281_pci_preinit,
.setup = orion5x_pci_sys_setup,
.scan = orion5x_pci_sys_scan_bus,
.map_irq = db88f5281_pci_map_irq,
};
static int __init db88f5281_pci_init(void)
{
if (machine_is_db88f5281())
pci_common_init(&db88f5281_pci);
return 0;
}
subsys_initcall(db88f5281_pci_init);
/*****************************************************************************
* Ethernet
****************************************************************************/
static struct mv643xx_eth_platform_data db88f5281_eth_data = {
.phy_addr = MV643XX_ETH_PHY_ADDR(8),
};
/*****************************************************************************
* RTC DS1339 on I2C bus
****************************************************************************/
static struct i2c_board_info __initdata db88f5281_i2c_rtc = {
I2C_BOARD_INFO("ds1339", 0x68),
};
/*****************************************************************************
* General Setup
****************************************************************************/
static unsigned int db88f5281_mpp_modes[] __initdata = {
MPP0_GPIO, /* USB Over Current */
MPP1_GPIO, /* USB Vbat input */
MPP2_PCI_ARB, /* PCI_REQn[2] */
MPP3_PCI_ARB, /* PCI_GNTn[2] */
MPP4_PCI_ARB, /* PCI_REQn[3] */
MPP5_PCI_ARB, /* PCI_GNTn[3] */
MPP6_GPIO, /* JP0, CON17.2 */
MPP7_GPIO, /* JP1, CON17.1 */
MPP8_GPIO, /* JP2, CON11.2 */
MPP9_GPIO, /* JP3, CON11.3 */
MPP10_GPIO, /* RTC int */
MPP11_GPIO, /* Baud Rate Generator */
MPP12_GPIO, /* PCI int 1 */
MPP13_GPIO, /* PCI int 2 */
MPP14_NAND, /* NAND_REn[2] */
MPP15_NAND, /* NAND_WEn[2] */
MPP16_UART, /* UART1_RX */
MPP17_UART, /* UART1_TX */
MPP18_UART, /* UART1_CTSn */
MPP19_UART, /* UART1_RTSn */
0,
};
static void __init db88f5281_init(void)
{
/*
* Basic Orion setup. Need to be called early.
*/
orion5x_init();
orion5x_mpp_conf(db88f5281_mpp_modes);
writel(0, MPP_DEV_CTRL); /* DEV_D[31:16] */
/*
* Configure peripherals.
*/
orion5x_ehci0_init();
orion5x_eth_init(&db88f5281_eth_data);
orion5x_i2c_init();
orion5x_uart0_init();
orion5x_uart1_init();
mvebu_mbus_add_window_by_id(ORION_MBUS_DEVBUS_BOOT_TARGET,
ORION_MBUS_DEVBUS_BOOT_ATTR,
DB88F5281_NOR_BOOT_BASE,
DB88F5281_NOR_BOOT_SIZE);
platform_device_register(&db88f5281_boot_flash);
mvebu_mbus_add_window_by_id(ORION_MBUS_DEVBUS_TARGET(0),
ORION_MBUS_DEVBUS_ATTR(0),
DB88F5281_7SEG_BASE,
DB88F5281_7SEG_SIZE);
mvebu_mbus_add_window_by_id(ORION_MBUS_DEVBUS_TARGET(1),
ORION_MBUS_DEVBUS_ATTR(1),
DB88F5281_NOR_BASE,
DB88F5281_NOR_SIZE);
platform_device_register(&db88f5281_nor_flash);
mvebu_mbus_add_window_by_id(ORION_MBUS_DEVBUS_TARGET(2),
ORION_MBUS_DEVBUS_ATTR(2),
DB88F5281_NAND_BASE,
DB88F5281_NAND_SIZE);
platform_device_register(&db88f5281_nand_flash);
i2c_register_board_info(0, &db88f5281_i2c_rtc, 1);
}
MACHINE_START(DB88F5281, "Marvell Orion-2 Development Board")
/* Maintainer: Tzachi Perelstein <tzachi@marvell.com> */
.atag_offset = 0x100,
.init_machine = db88f5281_init,
.map_io = orion5x_map_io,
.init_early = orion5x_init_early,
.init_irq = orion5x_init_irq,
.init_time = orion5x_timer_init,
.restart = orion5x_restart,
MACHINE_END